Swage Bolt Hex Adjuster Button End Stopper Bevel Washer SR
This kit contains enough fittings to create a single run of wire, up to 10M in length. One end of the run uses an M6 Hex Adjuster with an M6 Swage Thread Terminal to create tension, and the other end uses a swage end stopper to prevent twisting the wire. Bevel Washers at either end allow for use on angled installations.
Description
Swage Bolt Hex Adjuster Button End Stopper SR Kit suits a short run of wire of 10 meters or less (SR = Short Run). Firstly, fittings suit a run of wire up to 10 meters in length. Secondly, there is one tensioning point. Finally, there are enough fittings for a single wire run. Interestingly, this kit works on both Metal and Timber Posts – you just have to drill through.
Usage: Installation of the Swage Bolt Hex Adjuster Button End Stopper SR is easy. In this application one end uses an M6 Hex Adjuster with an M6 Swage Thread Terminal to create the required tension. Conversely, the other end uses a swage end stopper (sometimes called a rod end, or end stop) to prevent twisting the wire. Finally, the fittings require hydraulic swaging. Firstly, cut the wire to length. Secondly, swage the button end. Thirdly, feed the wire through pre-drilled intermediate posts. Finally, swage the thread terminal on, screw on the hex adjuster – and using a hex key – apply tension.
Contents
- RHT Swage Bolt M6 Stainless Steel 316 Marine Grade (1 included)
- Hex Adjuster M6 Stainless Steel 316 Marine Grade (1 included)
- Button End Swage Stopper Stainless Steel 316 Marine Grade (1 included)
- 37 Degree Bevel Washer Stainless Steel 316 Marine Grade (2 included)
Characteristics
- Balustrade Kit for 1 Runs/Wire
- Post Connections MM (Metal to Metal)
- Recommended Run Length <10M (SR)
- Swaging Method: Hydraulic
- Wire Structure: 7×7, 1×19
- Diameter of Wire: 3.2mm, 4.0mm
- Section Orientation: Stairs, Angle
- Wire Orientation in a Section: Horizontal, Vertical