Swage Bolt Timber Insert End Stopper SRTT

Description

Swage Bolt Timber Insert End Stopper SRTT

This Swage Bolt Timber Insert End Stopper SRTT kit includes fittings suitable for a Vertical Run wire, up to 10 metres in length, as there is one tensioning point. There are enough fittings for a single wire run.

Application:

In this application, both ends are fed through holes drilled in the end posts. One end of the run uses an Timber Insert with an M6 Swage Thread Terminal to create the required tension, and the other end uses a swage end stopper (sometimes called a dome end, or end stop) to prevent twisting the wire.

The fittings must use hydraulic swaging. They suit wire runs of 3.2mm Stainless steel wire rope, provided it measures less than 10 metres. The length of a wire run is measured from the inside of each end post.Installation of theSwage Bolt Timber Insert End Stopper SRTT kit is simple. Cut the wire to length, swage the dome end, feed the wire through pre-drilled intermediate posts, swage the thread terminal on, and screw into the timber insert to apply tension.

Contents

• M6 Timber Insert (Female) G316 Stainless Steel (1 included)
• M6 Swage Thread Terminal (Male) G316 Stainless Steel (1 included)
• Swage End Stopper (1 included)
• 6mm Flat Washer (1 included)

Characteristics

• Balustrade Kit forPack Size Runs/Wire
• Post Connections TT (Timber to Timber)
• Recommended Run Length<10M (SR)
• Swaging Method:Hydraulic
• Wire Structure:7×7, 1×19
• Diameter of Wire:3.2mm, 4.0mm
• Section Orientation:Flat, Stairs, Angle (however, you must use additional swivels)
• Wire Orientation in a Section:Horizontal