Swage Bolt Hex Adjuster End Stopper SRMM
This Swage Bolt Hex Adjuster End Stopper SRMM kit includes fittings suitable for a run of wire, up to 10 metres in length, as there is one tensioning point. There are enough fittings for a single wire run:
- 1 – M6 Hex Adjuster (Female) G316 Stainless Steel
- 1 – M6 Swage Thread Terminal (Male) G316 Stainless Steel
- 1 – Swage End Stopper
In this application, both ends are fed through holes drilled in the end posts. One end of the run uses an M6 Hex Adjuster with an >M6 Swage Thread Terminal to create the required tension, and the other end uses a swage end stopper (sometimes called a dome end, or end stop) to prevent twisting the wire.
The fittings can be manually swaged, but for best results we strongly recommend hydraulic swaging. They suit wire runs of 3.2mm Stainless steel wire rope, provided it measures less than 10 metres. The length of a wire run is measured from the inside of each end post.
Installation is simple. Cut the wire to length, swage the dome end, feed the wire through pre-drilled intermediate posts, swage the thread terminal on, and screw into the hex adjuster, using a hex key to apply tension.