Jaw Jaw Rigging Screw Thimble Swage Short Eye Bolt Lag Screw SRTM
This kitsuits manually swaging a run of wire of 10 meters or less (hence the SR orShortRun) as thereis a single tensioning point.Attachments are an M6x1.0 Mini Eye Bolts and a 6mmx40mm Short Lag Eye Screw to attach directly the posts (hence the TM or Timber to Metal).
Description
Jaw Jaw Rigging Screw Thimble Swage Short Eye Bolt Lag Screw SRTM kit suits a run of 3.2mm wire of 10 meters or less (hence the SR or Short Run). There a single tensioning point and two attachment points. attachments are a M6x1.0x15mm (Short or Mini) Eye Bolt (for the metal post) and a 6mm x 30mm Short Lag Eye Screw (for the Timber Post). These attach directly into posts (hence the TM or Timber to Metal).
Application The first end of the run has a 5mm Jaw / Jaw Rigging Screw (for wire tensioning) swaged to the wire. The jaw of this attaches to the Eye Bolt. The other Jaw attaches to the wire using a terminal loop formed with a ferrule and a swage. The Eye Bolt is fastens to a metal post or stud. The second end uses a terminal loop formed with a ferrule and a swage to attach to the Lag Swage Eye Screw which is fastened to the second post or wall.
Wire may be installed through the intermediate posts and ‘cut to length’. Please make sure you expand the turnbuckles before measurement and drill the intermediate posts out to at least 4mm prior to swaging in place. Alternately, if you build the wire before you install it, then the length of a wire run is determined by the ‘inside to inside’ post measurement less a fixed amount which represents the distance between the attachment posts ‘taken up’ by the fittings when installed and adjusted properly.
We recommend our Drill Taps (for drilling and tapping the metal posts) for installation of the Eye Bolts. Optionally, you can use Nutserts which afford an excellent structural alternative. And we have a Lag Eye Drier for the Lag Eye Screws.
Also – in your intermediate metal posts – we strongly recommend the use of stand grommets (flat areas) and angle grommets (ramps or stairs) for any non-stainless intermediate posts (to avoid a dissimilar alloys reaction).
Contents
- Eye Bolt M6x1.0x15mm Stainless Steel 316 Marine Grade (1 included)
- Lag Screw Eye 6mm x 40mm G316 Stainless Steel (1 included)
- Jaw/ Jaw Rigging Screw G316 Stainless Steel Marine Grade (1 included)
- Nickel Coated Copper Ferrules (2 included)
- Thimbles G316 Stainless Steel (2 included)
Characteristics
- Balustrade Kit for 1 Runs/Wire
- Post Connections TM (Timber to Metal)
- Recommended Run Length <10M (SR)
- Swaging Method: Manual
- Wire Structure: 7×7, 7×19
- Diameter of Wire: 2.4mm, 3.2mm 4.0mm
- Section Orientation: Flat, Stairs, Angle
- Wire Orientation in a Section: Horizontal, Vertical