: Safety Wire PEPE-4.0 200mm 1.5mm 7X7 G316 Stainless Steel ##

Description

Safety Wire PEPE-4.0 1.5mm 200mm 7X7 G316 Stainless Steel

Materials per wire:

1. 2 x 4.0mm G304 Pressed Eyes
2. Blank of 1.5mm 7×7 G316 Stainless Steel Wire Rope

Construction:

1. Each Pressed Eye extends the length of wire by 7.0mm to CofE when held as close as possible in the small vise grips
2. Cut blanks to 186mm = 200 – (2*7.0mm)
3. Select a Pressed Eye and using the smallest vise grips hold the pressed eye as close to the ‘tube’ as possible, then “round” the crimping tube with cold forging using
   • the bench swager and the 1.5mm aperture, or
   • “round” hand crimper
4. Using the C-Head and the Yellow Press with YCP-70C Dies (anvil and round 1.5mm)
   • Hold the rounded pressed eye as close to the ‘tube’ as possible
   • Place the open side of the round in the half tube side of the die set – holding the eye up tight from the side and into the dies.
   • Insert the blank all the way and place the formed pressed eye into the dies and exert compression force
     • until the pressure relief valve is triggered on the YCP-70C, or
     • until 1000 PSI on the Bench Press
5. Repeat for the other side
6. Align the faces of the pressed eyes.