: Safety Wire PEPE-3.0 300mm 1.5mm 7X7 G316 Stainless Steel ##

Description

Cut Wire Blanks of 1.5mm 7×7 G316 where

CoE to CoE Target length is 300mm

Each Pressed Eye extends the length of wire by 7.0mm to CofE when held as close as possible in the small vise grips

Cut blanks to 286mm = 300 – (2*7.0mm)

Hold Pressed Eye in small vise grips and “round the U” using the bench swager and the 1.5mm dies

Using the C-Head and the Yellow Press with YCP-70C Dies (anvil and round 1.5mm)

Hold the rounded pressed eye in the vise grips and place the open side of the round in the half tube side of the die set – holding the eye up tight from the side and into the dies.

Insert the blank all the way and press to the 1/4 distance.

repeat for the other side

If possible – align the faces of the pressed eyes.