Lag Screw RHT LHT SRTT BlackTech

Description

BlackTech Lag Screw RHT LHT SRTT
Lag Screw RHT LHT SRTT Kit suits a run of wire of 10 meters or less (hence the SR or Short Run). And its 316 Stainless – but this set is BLACK. There is a Right Hand Thread (RHT) & a Left Hand Thread (LHT) Terminal Lag Screw that form two attachment points. These attach directly into softwood or hardwood timber posts (hence the TT or Timber to Timber).

Application
The Lag Screw RHT LHT SRTT has two ends. The first end of the run has a RHT Lag Screw swaged to the wire. This attaches to the first timber post or wall. The second end uses an LHT Lag Screw which is fastened to the second post or wall. Wire may be installed through the intermediate posts and ‘cut to length’. Please ensure you cut the wire beforehand. It is VERY difficult to ‘cut to size’ once the Terminal Lag Screws are installed. Drill the intermediate posts out to at least 4mm prior to swaging in place.

Alternately, if you build the wire before you install it, then the length of a wire run is determined by the ‘inside to inside’ post measurement less a fixed amount which represents the distance between the attachment posts ‘taken up’ by the fittings when installed and adjusted properly. This number represents the amount we would cut off in the factory to custom build wires with this kit for a given length. We recommend cutting, building, installing and reviewing your installation to ensure that it looks the way YOU want it to look once its complete.

Contents

• BlackTech 6mm X 40mm RHT Lag Screw Stainless Steel 316 Marine Grade (1 included)
• BlackTech 6mm X 40mm LHT Lag Screw Stainless Steel 316 Marine Grade (1 included)

Characteristics

• Balustrade Kit for 1 Runs/Wire
• Post Connections TT (Timber to Timber
• Recommended Run Length <10M (SR)
• Swaging Method: Hydraulic
• Wire Structure: 1×19 (BlackTech Recommended)
• Diameter of Wire: 3.2mm
• Section Orientation: Flat, Stairs, Angle
• Wire Orientation in a Section: Horizontal, Vertical